How To Assemble - Dirt Devil featherlite Carpet Shampooer Operating, And Servicing Instructions

TOOL REQUIRED: PHILLIPS SCREWDRIVER
Stand base in upright position. Push midsection
onto base by aligning tabs on the backside of
midsection with the pockets on the backside of
base. One at a time, place nut into recess located
on the back of the left, right and middle back of
the base. While holding nut in place, insert screw
through front of midsection and tighten. Repeat
this process with the remaining two (2) nuts and
screws. NOTE: Make sure the power cord is out of
the way to avoid pinching.
Slide upper handle down onto unit.
Place nut into recess in back of upper
handle. While holdina nut in dace.
insert screw throughfront of'upp& han-
dle and tighten. Route cord above upper
cord hook and snap into cord clip on
upper handle.