Related Manuals for Directed Video Directed Video VC2050
Summary of Contents for Directed Video Directed Video VC2050
- Page 1 O W N E R ’ S G U I D E INSTALLATION GUIDE Video Cassette Recorder with TV Tuner MODEL VC2050...
-
Page 3: Limited One-Year Warranty
Limited One-Year Warranty For a period of ONE YEAR from the date of purchase, Directed Electronics, Inc. ("DIRECTED") promises to the original purchaser to repair or replace, free of cost, with a comparable reconditioned model any VIDEO CASSETTE RECORDER (hereafter the "UNIT”), which... -
Page 4: Safety Instructions
Power Cord Wiring Harness - The power cord should be routed in such a way that it is not likely to be stepped on, have objects placed on it, shorted to ground, or hinder operation of the vehicle in any way. © 2001 Directed Electronics, Inc. -
Page 5: Important Information
© 2001 Directed Electronics, Inc. The product does not operate normally according to the operating instructions. Adjust only those controls covered by the operating... -
Page 6: Table Of Contents
........13 © 2001 Directed Electronics, Inc. -
Page 7: Features
Infrared remote control. On-screen display. Built-in 125-channel TV tuner. Remote Ejection - tape can be ejected using the remote control. © 2001 Directed Electronics, Inc. ACCESSORIES VCR. Remote infrared (IR) sensor (Optional part). Antenna. Remote control. AA Batteries for remote. -
Page 8: Front Panel
The VCR cannot be mounted upside down or on its side. The VCR is sensitive to dirt and other contaminants. Do not mount the unit or VCR is overheated, the VCR will not be able to work. -
Page 9: Rear Panel/Tv Connection/Power
Rear Panel/TV Connection/Power To connect the VCR and TV, use cable type (A/V RCA-type) appropriate to your TV. Connect the VCR and TV as shown: Back of TV AUDIO IN VIDEO IN On TV ON TV VIDEO OUT - Connects to TV video input. -
Page 10: Remote Control
Remote Control Always aim the remote control directly at the VCR or the remote sensor eye. Remote Control Battery Install/Replace Slide battery compartment cover out from back of remote control. Insert two AA batteries as diagrammed. Slide battery compartment cover back in. -
Page 11: Playing A Tape
TV to video mode. If connected with RF cable, set TV to channel 3 or 4 and set VCR output to channel 3 or 4 in the MAIN MENU. (Refer to page 11.) Load a video cassette tape. VCR power turns on automatically. -
Page 12: Videocassette Tapes
NOTE: Keep cassettes from direct sunlight, heat, or extreme cold. Do not drop cassettes. Never touch the recording surface of the tape. © 2001 Directed Electronics, Inc. (super longplay) -
Page 13: Using Special Features
IMPORTANT! DO NOT INSERT ANY OBJECTS INTO THE CABINET SLOTS; CONTACT WITH A VOLTAGE POINT INSIDE THE VCR CAN CAUSE DANGEROUS SHOCK OR MAY SHORT OUT PARTS AND CAUSE FIRE OR ELECTRIC SHOCK. © 2001 Directed Electronics, Inc. -
Page 14: Setting The Main Menu
If the setup menu does not appear, make RECORD SPEED The VCR can record at two tape speeds. The slower speed (SLP) allows the VCR to record more program material on a tape. Tapes recorded at standard speed (SP) provide a clearer picture. (See page 12.) -
Page 15: Audio Output
Channel Add/delete can be used. VCR OUTPUT CH VCR sends the output signals to channel 3 or 4 on your TV. Set the output channel on the menu to 3 CH or 4 CH, whichever is vacant in your area. -
Page 16: Troubleshooting
Make sure the VCR is on and connected to an operating power source; check the remote for “good” batteries. Press EJECT to see if a cassette is already in the VCR. Make sure the videocassette is window-side up, with the arrow pointing toward the VCR. -
Page 17: Specifications
Signal-to-noise ratio Power source Power consumption Dimensions Fuse Weight Your VCR can receive 68 broadcast TV channels or up to 125 unscrambled cable channels. Check your local cable company for complete compatibility requirements. Type Number On Air CATV Total 181 ©... - Page 18 The recipient of more than 20 patents in the field of advanced electronic technology, Directed is ISO 9001 registered. Quality Directed Electronics products are sold and serviced throughout North America and around the world. Call (800) 274-0200 for more information about our products and services.
Need help?
Do you have a question about the Directed Video VC2050 and is the answer not in the manual?
Questions and answers