PRESONUS FIREPODOD Manual page 14

INSTALLATION AND SET UP
Record enable the track by pressing the Record Enable button.
Plug a microphone into channel one and turn on 48V phantom power if needed for the microphone. Turn up
the channel 1 trim control on the front panel of the FIREPD while speaking into the microphone. You should
see the input meter react to your speaking. Adjust trim so that input level at maximum without clipping.
Connect a set of headphones to the FIREPOD headphone output.
Click the monitor button in Cubase LE for Audio 01.
Adjust the MIX control counter clockwise to monitor input only for zero latency. Turn MIX control clockwise to
monitor through the computer and Cubase LE.
Note that online help available for Cubase LE by pressing F1 or visiting www.steinberg.net
22