This diagram shows the DigiMax D8 used as a splitter; sending the analog direct outputs to an analog monitor mixer and the ADAT output to a digital
Front of House console. The digital outputs of the FOH console are then being sent to the FireStudio Lightpipe so that the performance can be recorded
on a computer. The entire digital signal path is being clocked to the digital console via BNC, so the 3 DigiMax FS and the FireStudio Lightpipe must be
set to clock externally via BNC. Because of the compact size of the DigiMax D8, it is necessary to use a BNC T-Connector with 3 Female inputs, rather
than the standard Male - Female - Female iteration when using both parallel wordclock distribution and all 8 direct analog outputs at the same time.