Dockable Media Player-Installation - Directed Electronics OHV1021 Owner's Installation Manual

Dockable Media Player—
Installation
1. Be sure the media player is off, ensure power to the OHD console is off, and
that the ignition key is off.
2. Align the notches in the side of the media player with the tabs in the sides
of the monitor POD mounting area and slide the player into the monitor.
3. Slide the player towards the LCD screen until the lock/unlock button latches.
NOTE: Remove the rubber protective cover over the electrical connector at the bottom
of the media player before installing in the monitor POD mounting area. Store
the protective cover on the slot provided on the back of the media player for
reinstallation when the media player is unmounted.
NOTE: If the player doesn't power up correctly, remove the player (see instructions
below) and then re-install.
Lock/Unlock
54
Button
Electrical
Connector
Insert Player
and then slide down
until unit locks.
© 2005 Directed Electronics—all rights reserved