Table of Contents
Advertisement
Part 2: Repair Information
7. LAMP REPLACEMENT
WARNING
Procedure
1. Turn off the projector and disconnect the AC
cord. Allow the projector to cool for at lease 45
minutes.
2. Remove a screw with a screwdriver and remove
the lamp cover.
3. Remove 2 screws and pull out the lamp
assembly by grasping the handle.
4. Replace the lamp assembly securely and
tighten 2 screws.
5. Place the lamp cover and tighten a screw.
6. Connect the AC cord to the projector and turn
on.
7. Reset the lamp replacement monitor timer, see
below explanation.
Service Parts No.: DY4-6108-000
Description: Lamp A'ssy LV-LP10
CAUTION
How to reset the lamp replacement monitor timer
1. Turn the projector on, and press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT buttons to select SETTING and press the
SELECT button. Another dialog box SETTING MENU will appear.
2. Press the POINT DOWN button and a red arrow icon will appear. Move the arrow to
"Lamp age", and then press the SELECT button. The message "Lamp replace monitor
Reset?" is displayed.
3. Select [Yes] to reset the Timer.
Please refer to the owners manual for further information.
• For continued safety, replace with a lamp assembly of the same type.
• Allow the projector to cool for at least 45 minutes before you open
the lamp cover. The inside of the projector can become very hot.
• Do not drop the lamp module or touch the glass bulb! The glass can
shatter and cause injury.
• Do not reset the Lamp Replacement Monitor Timer, except after the
lamp is replaced.
• The projector can not be turned-on with the lamp cover removed,
because when the lamp cover is removed, the interlock switch is also
released to switch off the mains power for safety.
Lamp cover
Lamp Assembly
2-18
Handle
Fig. 2-25
Advertisement
Table of Contents
