Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT REV 1 Manual page 76

70 M R
ANAGING EPORTS
Step 3
Select a scheduling option. Click Next.
Table 5-3 Report Scheduling
Parameter
This report should be scheduled to run
Manually
Hourly
Daily
Weekly
STRM Log Management Users Guide
Default Settings
Generates a report one time only. This is the default setting;
however, you may generate this report as often as required.
Schedules the report to generate at the end of each hour
using the data from the previous hour.
Using the drop-down list boxes, select a time frame to begin
and end the reporting cycle. A report is generated for each
hour within this time frame. Time is available in half-hour
increments. The default is 1:00 a.m for both From and To.
Schedules the report to generate each day using the data
from the previous day. Each chart on a report allows you to
select the previous 24 hours of the day, or select a specific
time frame from the previous day.
Click the check boxes beside each day you wish to generate
a report. Also, using the drop-down list box, select a time to
begin the reporting cycle. Time is available in half-hour
increments. The default is 1:00 a.m.
Schedules the report to generate each week using the data
from the previous week.
Select the day you wish to generate the report. Default is
Monday. Using the drop-down list box, select a time to begin
the reporting cycle. Time is available in half-hour increments.
The default is 1:00 a.m.