Thermaltake TT Pacific V-RTX 2070 Plus Manual

thermaltake
This product is intended for installation only by expert users. Please consult with a qualified technician
Improper installation may result in damage to your equipment.
Before you start using this product please follow these basic guidelines:
1. Please carefully read through the instruction manual before beginning the installation process.
2. Please remove your graphics
your CPU and motherboard.
3. It is strongly recommended
O
Remove original VGA stock cooler (Remove
the screws circled on the diagram.
assembly screws should be removed)
Remove the
power connector
9
When installing the water block, carefully
on the graphics card.
RoHS
COMPLIANT
Pacific
card from your motherboard
to use market proven pre-mix coolant, such as Thermaltake
@ x 13
Remove the power connector
All heat sink
Apply thermal compound
p
position the water block with the preinstalled
0 2018 Thermaltake Technology
www.thermaltake.com
V-RTX
ASUS Strix
to insure the safest process
Parts List
Clean the original thermal compound off the GPU die and remove the
screws to detach the backplate.
after removing all acrews securing the cooler to the board)
62m m
O
30mm 30mm
97mm
9m m c
1
97mm
9m m c
Cut the thermal pads to the dimensions
standoffs
Co., Ltd. All Rights Reserved.
2070 Plus
VGA Water Block
for installation.
and in order to prevent any possible
Coolant 1000.
Ox 6
(Carefully detach the original stock cooler
listed and place them on the spots shown on the diagram.
thermaltake
.
Patented
RGB
16.8
damages to
Ox2
O
0
Finish