Cisco CVPN3015-NR - VPN Concentrator 3015 Getting Started page 75

Chapter 4 Using the Command-Line Interface for Quick Configuration
Per user—a server assigns IP addresses on a per-user basis. If you are using an authentication server
•
that has IP addresses configured, we recommend using this method. (You configure an
authentication server in the next section.)
DHCP (Dynamic Host Configuration Protocol)—a DHCP server assigns IP addresses.
•
Configured pool—the VPN Concentrator assigns IP addresses from an internally configured pool of
•
addresses.
You must enable at least one method. You can enable any and all methods. By default, no method is
enabled.
To configure address assignment, follow these steps:
The system prompts you to enable or disable client-specified address assignment. If you enable IPSec,
Step 1
do not enable only this method; IPSec does not allow client-specified IP addresses.
-- : Configure address assignment for PPTP, L2TP and IPSec.
1) Enable Client Specified Address Assignment
2) Disable Client Specified Address Assignment
Quick -> [ 2 ]
At the cursor, enter
(2), disabled.
The system prompts you to enable or disable per-user address assignment.
Step 2
1) Enable Per User Address Assignment
2) Disable Per User Address Assignment
Quick -> [ 2 ] _
At the cursor, enter
disabled.
The system prompts you to enable or disable DHCP address assignment.
Step 3
1) Enable DHCP Address Assignment
2) Disable DHCP Address Assignment
Quick -> [ 2 ] _
At the cursor, enter
disabled. If you enable DHCP, continue with the next step. If you disable DHCP, skip the next step.
If you enable DHCP address assignment, the system prompts for the server address. If you disable
Step 4
DHCP, this prompt does not appear.
> DHCP Server
Quick -> _
At the cursor, enter the IP address or hostname of the DHCP server.
The system prompts you to enable or disable configured pool address assignment.
Step 5
1) Enable Configured Pool Address Assignment
2) Disable Configured Pool Address Assignment
Quick -> [ 2 ] _
78-15733-03
to enable client-specified address assignment, or press Enter to accept the default
1
to enable per-user address assignment, or press Enter to accept the default (2),
1
to enable DHCP address assignment, or press Enter to accept the default (2),
1
Configuring Address Assignment
VPN 3000 Series Concentrator Getting Started
4-7