Kurzweil K2500 - PERFORMANCE GUIDE REV F PART NUMBER 910251 CHAP 15 Sampling Manual page 25

values are LIN, EXP, COS, EQL, and MIX. These curves are described at the end of the section
on DSP functions.
Like the crossfade parameter in the Delete function, this crossfade will also shorten the sample.
The maximum crossfade length is half the length of the reversed segment.
7 Invert
F:Invert|||||Start:0.000||||End:6.000|||
||||||||||||||||||||||||||||||||||||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
Use this function to invert the waveform of the selected sample range. This reverses the phase
of the sample. You won't hear any difference unless it is played in reference with the original
sample.
The results will vary depending on the type of sample. For an interesting phase effect, make a
copy of a sample, then invert the copy, then assign it to the keymap of a second layer in a
program that uses the original sample in the keymap of the first layer (or set them as the Left
and Right samples in a stereo keymap). Add a delay to one of the layers or keymaps to create
the phase effect.
8 Insert Zero
F:InsertZero|Start:0.000||||End:6.000|||
Length:0.000||||||||||||||||||||||||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
This function will insert a period of silence of any length into the selected sample range. This
function is equivalent to splicing a section of blank tape into an existing segment of recorded
tape. It's useful for creating a delay on the start of a sample, or creating a silent spot in the
middle or at the end of the sample. Adjust the Start parameter to determine the point at which
the period of silence will begin. Adjust the Length parameter to specify how long the silence
will be. The End parameter has no effect for this function.
Sampling and Sample Editing
Editing Samples
15-25