Hatco Flav-R-Savor FS-1 Installation And Operating Manual
Hide thumbs
Also See for Flav-R-Savor FS-1:
- Installation and operating manual (16 pages) ,
- Installation and operating manual (16 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Hatco Flav-R-Savor FS-1
Summary of Contents for Hatco Flav-R-Savor FS-1
- Page 1 arca r,'0N Flav-R-Savor Installation Operating Manual Models: Display Cabinet Holding Cabinet...
- Page 2 TABLE CONTENTS Page No. Page No. GENERAL Holding Cabinet .. MODEL DESCRIPTION Auto-Fill. Draining Water Reservoir... Display Cabinet Stacking Units . Holding Cabinet Stacking Hardware .. SPECIFICATIONS FOOD HOLDING Dimensions RECOMMENDATIONS GUIDE Electrical CLEANING INSTALLATION PROCEDURES MAINTENANCE. Reversing Access Door..Display Cabinet Models With...
- Page 3 *'just made" quality. Hatco holding and display cabinets provide the best environ- ment for food products by regulating the air temperature while at the same time balancing the humidity level.
- Page 4 Model FS-I FST-I The EST-IX is a single door model with a tray rack that holds up to tour 13 x 18 in. tooo pans, The rack is slanted See Figure I at the front to allow viewing Ot all trays. The FS-I is a standard single door model with revolving display motor.
- Page 5 SPECIFICATIONS Holding Cabinet Dimensions —22314 Display Cabinet 33 in. on:o Front View Front View 360/4 in. with 3 in. casters 227/8 in. (Model FS) in. (Model FST) Side View Figure 6. Holding Cabinet Di mensions with 3 in. Casters Electrical Side View All models are shipped with a pre-wired...
- Page 6 Holding Cabinet Display Cabinet 1680 watts/14 amps 1790 watts/'4.9 amps Export Voltages Display Cabinet Holding Cabinet 230 volt, single phase 220 volti single phase 1660 watts using amps 1790 watts using 7.4 amps INSTALLATION PROCEDURES Reversing Access Door Remove vent plug and discard All Models See Figure...
- Page 7 Casters The Flav-R-Savor access door may be hinged at lett or right for greater convenience. The unit is shipped with the TO install the casters, lay the cabinet on its side, door hinged left, TO change to right opening; NOTE 1.
- Page 8 Plug the Flav-R-Savor into a proper receptacle and it is Recessed Casters ready to operate. Follow the steps under OPERATING See Figure 10, Each recessed caster is mounted to the PROCEDURES cabinet underside with four screws washers. Assem- ble casters to the special brackets provided at the bottom of the cabinet.
- Page 9 The reservoir capacity permits uninterrupted operation OPERATING for approximately 8-12 hours depending upon settings PROCEDURES and how frequently the door is opened. When the red low water indicator light is on. add water to the reservoir. See Figure 12 Water Reservoir i, Turn the power switch at the control panel to "ON."...
- Page 10 Holding Cabinet See Figure The reservoir fill is located on the left front Of the cabinet. Pull the fill tray forward just enough to open (do not pull out completely), Fill reservoir with distilled water. Push till tray in to close, Auto-Fill See Figures 15 and 16...
- Page 11 Draining Water Reservoir Model FSHC See Figure 17 It is recommended that the Flav-R-Savor holding cabinet water reservoir be drained prior to moving the unit. This will prevent water from spilling into the food compartment. Drain hole A quick-connect coupling and tube assembly is provided Coupling with tube with each unit to allow fast and easy draining of the...
- Page 12 FOOD HOLDING RECOMMENDATIONS GUIDE HOLDING TIME SETTINGS TYPES FOOD MAXIMUM MOISTURE TEMPERATURE SETTING (OF) LEVEL SETTING HOLDING TIME 5 hours Medium 4-1/2 (150) Baked Potatoes hours 4 (140) Bagels Medium 3 (130) Biscuits 2 hours Hign 5 (175) Chicken Parts (Broasted) 5 hours Croissants 3 hours...
- Page 13 Figure 18. Gear Motor Models with Revolving Models With Motorized Display Revolving Display See Figure 18 ACCESSORIES Add oil to lubricate gears evetysix months Hatco lubricati ng Display Cabinet Models oil (Mobil SHC-634, Hatco Part No 05-01-023) is re- commended. Display Racks SAFETY...
- Page 14 Holding Cabinet Models Merchandising Display Sign Recessed Casters Mounts to the top using existing screws. Includes a preprinted sign and plexiglass "window," Allows unit to fit under most standard kitchen counters. Stacking Hardware Adjustable Legs Recommended when stacking a Flav.R.Savor display 4 in.
- Page 15 BLOWER FAN OIL PROCEDURE LUBRICATE EVERY 3 MO. t. Remove motor bearing Oiler plugs add oil and replace plugs. 2. Rotate access cover on top of air chamber to Oil blower bearing Remove plug. add oil and replace. HATCO OIL, PART NO. 05-01-019...
- Page 16 Acres€ory Components (including but not limited to valves, Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns Shall...
Need help?
Do you have a question about the Flav-R-Savor FS-1 and is the answer not in the manual?
Questions and answers