model OS1.0
Setup Guide
U.S. Pat. Nos. 4642606/5904442/Pat. and Design Pat. Pending
Copyright© Aug. 2000 CAT EYE Co., Ltd.
The position of the sensor and the magnet should be as shown:
Side view
Top view
mark line
Align the center of the magnet
The clearance between the
and the sensor's mark line while ro-
sensor
tating the wheel or crank.
should be less than 10 mm.
Mounting View
Parts of Names
®
E E
2
OS1SME-001019 066600061
less than 10 mm
and the magnet
2
Speed Sensor
1
Magnet
Peel off
Spoke
Bracket
Wire
Speed sensor
Bracket band
Sensor spacer
Magnet
Nylon tie
Bracket screw (long)
Sensor screw (short)
Lithium battery
(CR2032)
Bracket rubber pad
Front fork
C
Fasten the screws
securely
4
Bracket
3
Wire
5
Main Unit
Remove
Lever
To remove
Push
Pull
Caution!:
Insure enough wire clearance in the
area marked with
to allow the
handlebar to fully rotate without pulling
the wire.
Mount