Cateye OS 1.1 Setup Manual

model OS 1 .1
Read me first.
Setup Guide
U.S. Pat. Nos. 4642606/5904442/Pat. and Design Pat. Pending
The position of the sensor and the magnet should be as shown:
Side view Top view
mark line
Align the center of the magnet
The clearance between the
and the sensor's mark line while ro-
sensor
tating the wheel or crank. should be less than 10 mm.
Mounting View
Part Names
®
E E
Copyright© 2001 CAT EYE Co., Ltd.
1
OS1.1SE-011025 066600151
less than 10 mm
and the magnet
2 Speed Sensor
1 Magnet
Peel off
Spoke
Rubber pad
Bracket
Wire
Speed sensor
Bracket band
Sensor spacer
Magnet
Nylon tie
Bracket screw (long)
Sensor screw (short)
Lithium battery
(CR2032)
Bracket rubber pad
Front fork
C
Fasten the screws
securely
4 Bracket
3 Wire
5 Main Unit
Remove
Lever
To remove
Push
Pull
Caution!:
Insure enough wire clearance in the
area marked with to allow the
handlebar to fully rotate without pulling
the wire.
Mount