DigiTech RP1000 Owner's Manual page 10

select the Wah row to adjust this parameter when USB is connected to the RP1000.
3. When the Expression row is selected, this knob selects the LFO waveform. LFO 1or
LFO 2 must first be selected with Knob 1 for this parameter to be available.
Master Volume (Knob 6)
1. In Performance mode, this knob adjusts the output level of the RP1000.
2. When editing a preset, this knob modifies the parameter listed in the column directly
above it for the selected Effect row.
3. When the Expression row is selected, this knob sets the LFO speed. LFO 1or LFO 2
must first be selected with Knob 1 for this parameter to be available.
9. Looper Button
This button enables and disables the RP1000's loop phrase sampler. The Looper can be used
at any time during RP1000 operation and offers the ability to create mono loop phrases of up
to 20 seconds in length. Three LEDs (Record/Play/Overdub) indicate the status of the Looper
during use. While the Looper is active, the Bank Up/Down footswitches change function to
control the Looper record, overdub, playback, and loop clear functions.
10. System Buttons
There are three system buttons: AMP/CABINET BYPASS, PEDALBOARD, and STORE.
Amp/Cabinet Bypass
1.
passed in all RP1000 presets
Pedalboard
2.
labeled above them on and off. When the button is not lit, these footswitches select
the five presets in the active bank.
Store
3.
11. Bank Up/Down Footswitches
These Up/Down footswitches select preset banks. When Pedalboard mode is active, there are
20 banks of 5 presets. When Preset mode is active (Pedalboard button is disabled) there are 10
banks of 10 presets. When the Looper is active, these footswitches control Record, Playback,
Overdub, Stop, and Loop Clear functions. Refer to page 33 for more information on using the
Looper.
12. Expression Pedal
The Expression Pedal provides real-time control of the RP1000's Volume, Wah, or any assigned
effect parameter. Almost every parameter is available for Expression Pedal control. The Expres-
sion Pedal is equipped with a V-switch that turns on and controls the Wah effect when you apply
extra pressure to the toe.
13. 1-10 / Effects Footswitches
In Preset Mode, these 10 footswitches select between 10 different presets in the active bank
(10 banks of 10 presets). The footswitch LED will light to indicate which preset is active. When
Pedalboard mode is active, footswitches 1-5 will select between 5 different presets in the active
bank (20 banks of 5 presets) while footswitches 6-10 are used to turn Compressor, Distortion,
Chorus/FX, Delay, and Reverb effects on and off. Effects that are on will have their footswitch
LED lit.
6
– When this button is lit, amp and cabinet modeling is by-
– When this button is lit, the 5 numbered footswitches turn the effects
– Press this button to begin the store/copy procedure.