Led Designations; Port Leds - NETGEAR FS728TP - ProSafe 24 Port 10/100 Smart Switch Hardware Installation Manual

Figure 3-2 illustrates the NETGEAR FS728TP Smart Switch back panel:
Figure 3-2
The back panel contains the following:
• A 100-240VAC/50-60 Hz universal input, which is a standard AC power receptacle for
accommodating the supplied power cord.

LED Designations

This section provides an explanation for the following LED types:
•

Port LEDs

• System LEDs
Port LEDs
The following table describes the port LED designations.
Table 3-1. Port LEDs
Port
1-24 Port mode select
LED
24-10/100M Ports - One
LED/Port (Ethernet
Mode)
Physical Description
LED
Link/ACT/SPD LED
(Light Pipe)
v1.0, November 2007
FS728TP Hardware Installation Guide
Designation
• Solid Green - Device is in Ethernet Mode
(default).
• Solid Yellow - Device is in PoE Mode.
• Off - No 10/100Mbps link is established on the port.
• Solid Green - A valid 100Mbps link is established
on the port.
• Flashing Green - Packet transmission or reception
is occurring on the port at 100Mbps.
• Solid Yellow - A valid 10Mbps link is established
on the port.
• Flashing Yellow - Packet transmission or
reception is occurring on the port at 10Mbps.
3-20