Chapter 4: Bi-Admin Management; Overview; Bi-Admin Installation - Linksys PSUS4 - PrintServer For USB User Manual

Chapter 4
Chapter 4:
Bi-Admin Management

Overview

The PrintServer is managed by a utility program called
Bi-Admin on the PrintServer's Setup CD. Fully compatible
with Windows 98, Me, 2000, and XP, Bi-Admin allows you
to change the PrintServer's internal settings, check the
unit's status, and perform basic diagnostic tests.
Note that the Bi-Admin program must be installed only
on the network administrator's computer. First, you will
install Bi-Admin on your computer. Then, you will be able
to use the management utility.

Bi-Admin Installation

1. If you have not already done so, insert the Setup CD-
ROM into the PC's CD-ROM drive. The Setup CD-ROM
should run automatically. If it does not, click Start
and choose Run. In the box that appears, enter D:\
setupWizard.exe (if "D" is the letter of your CD-ROM
drive).
Welcome screen, click Bi-Admin
2. When you see the
Install to continue. Click Exit to end the installation.
Welcome
3. The Bi-Admin program's
If any other programs are open at this time, close
them before continuing; click Cancel to quit the setup
program, then close the open programs. Otherwise,
click Next to continue with the Bi-Admin installation.
PrintServer for USB with 4-Port Switch
Welcome screen will appear.
Bi-Admin Management
Bi-Admin Welcome
Choose Destination Location screen lists the default
4. The
location where the Bi-Admin folder will be installed. If
you want to install the folder in a different location, click
Browse and select the location. To install the folder in
the default location, click Next to continue. Click Back
to return to the previous screen. Click Cancel to end
the Bi-Admin installation.
Choose Destination Location
Select Program Folder screen appears. An icon
5. The
will be added to the program folder listed. If desired,
change the name for the program folder. Click Next.
Click Back to return to the previous screen. Click
Cancel to end the Bi-Admin installation.
Select Program Folder
9