Dell PowerConnect 6224 Release Note page 28

Summary User Impact
Bridge multicast If a user configures the bridge multicast
address is shown as address as an IP address format in VLAN
MAC Address format interface mode, it is displayed in the show
in show running- running-config command in MAC address
config buffer when it format.
is configured in IP
format.
Connected spanning A port that is a root port will not become auto
tree root port role not edge port if the bridge that the root port is
changed to auto- connected to goes away.
portfast after
disabling MSTP on
Trunk.
Three commands are The following commands are not available to
not available at use in interface range Ethernet level: isdp,
interface range lacpa, and protocol.
Ethernet level, but
are available at
interface.
There is no command The user cannot use interface ranges to
to add protocol vlan configure a protocol VLAN.
in interface range
mode.
Invalid error port When port is changed to forbidden mode
number displayed on from access mode, the log message below
log message when is generated that reports the wrong port
VLAN is changed to number.
forbidden mode from
access mode.
<187> OCT 12 08:39:03 10.131.6.173-1
DOT1Q[104741168]: dot1q_api.c(525) 2475
%% Port(88)
This log message is correct when a port
from the base unit is selected.
Gratuitous ARP If the user changes the management VLAN,
packets are not being then management connections must be re-
generated when established on the new VLAN. Neighbors
management VLAN is will resolve the switch's management IP
changed with static IP address on the new VLAN.
configuration.
Using interface range Cannot use interface range mode to
mode not able to configure protected switchports.
configure protected
ports.
TFTP fails to display If a user attempts to tftp a non-existent file to
specific error the image of the switch, nothing will be
message when downloaded and there will not be an error
incorrect filename message generated.
was given while
downloading the
code.
Web needs to provide User will not be able to select range of
an option to configure interfaces through web for the Sampler and
sFlow sampler / poller Poll Configuration web pages. However,
values on range of configuration is not affected as user can
interfaces. individually select the interfaces and
configure.
26
Workaround
None.
This means that the port would flush the
Forwarding Database entries every time that
there is a topology change. This could be
avoided if the link goes down and comes
back up.
Each interface must be configured
individually.
Each protocol VLAN must be configured
individually.
None.
None.
The user must configure each protected port
individually.
None.
User has to select each interface individually
to configure in the Sampler Configuration
and Poll Configuration web pages.
System Firmware Version 3.2.0.6