Novell LINUX ENTERPRISE SERVER 11 - SECURITY Manual page 299

The Profile Modes dialog allows you to view and edit the mode of currently loaded
AppArmor profiles. This feature is useful for determining the status of your system
during profile development. During the course of systemic profiling (see
"Systemic Profiling"
of the profiles for which you are learning behavior.
To edit an application's profile mode, proceed as follows:
1 Start YaST and select Novell AppArmor > AppArmor Control Panel.
2 In the Configure Profile Modes section, select Configure.
3 Select the profile for which to change the mode.
4 Select Toggle Mode to set this profile to complain mode or to enforce mode.
5 Apply your settings and leave YaST with Done.
To change the mode of all profiles, use Set All to Enforce or Set All to Complain.
TIP: Listing the Profiles Available
By default, only active profiles are listed—any profile that has a matching ap-
plication installed on your system. To set up a profile before installing the re-
spective application, click Show All Profiles and select the profile to configure
from the list that appears.
(page 292)), you can use this tool to adjust and monitor the scope
Building and Managing Profiles with YaST
Section 24.6.2,
285