Di-soric ID-02 Quick Start Manual

Quick Start Guide ID-02
Compact Industrial Scanner
Step 2 — Connect the System
Important: When connecting Ultra-Lock cordsets to the ID-02 and
VSID-IB-ES, align the pins first and then push the connector into
place. Do not twist the connectors, as this will bend the pins.
Important: Do not attempt to power more than four scanners with
a single power supply in a daisy chain configuration. Add a
VSID-IB-ES and one power supply for every four additional
scanners in the daisy chain.
RS-232
1. Connect the Serial Communication Cable from "A" on the ID-
02 to "2" on the VSID-IB-ES.
2. Connect the host cable from "1" on the VSID-IB-ES to the host
computer.
3. Connect the photo sensor to "T" on the
4. Connect the power supply to "3" on the
5. Plug in the power supply.
Ethernet
Important: Configure Ethernet-enabled readers off-line and then
connect to network when ready for dynamic use.
1. Connect the Ethernet Cable from "B" on the ID-02 to the net-
work.
2. Connect the power supply to "A" on the ID-02.
3. Plug in the power supply.
©2011 di-soric
P/N 83-110830 Rev E
Step 3 — Position Scanner
1. Place a test symbol in a location with as little ambient light as
possible.
2. Position the scanner at the focal distance used in your application.
3. Align the test symbol with the scanner's field of view.
4. Tip the scanner relative to the test symbol to avoid glare from
specular reflection.
Symbol
VSID-IB-ES.
VSID-IB-ES.
Skew
Tilt
Maximum
skew, tilt,
and pitch:
±30°
Pitch
Scanner
Step 1 — Check Hardware
1
3
2
2
Serial (with VSID- Ethernet (with VSID-
Hardware Required
Caution: Be sure that all connections are secure BEFORE applying
power. Always power down BEFORE disconnecting any cables.
Item Description
1 ID-02 Compact Industrial Scanner
2 Interface Device
3 Power Supply, M12 12-pin Socket, 1.3 m
Note: Additional cordsets and accessories are available in the di-soric Product Pricing Cat-
alog.
Step 4 — Install di-soirc ID
di-soirc ID Software can be found on the di-soric Tools USB
Stick that is packaged with the ID-02.
1. Follow the prompts to install di-soirc ID from the USB Stick.
2. Click on the di-soirc ID icon to run the program.
Note: di-soirc ID can also be installed from the Down-
load Center at www.di-soric.com.
Refer to the ID-02 Compact Industrial Scanner User's Manual
for detailed information about using di-soirc ID to configure the
ID-02.
1
3
Part Number
ID-02-LX-X-ES
VSID-IB-ES
VSID-PS-24V-ES