Novell LINUX ENTERPRISE SERVER 10 - STORAGE ADMINISTRATION GUIDE 7-2007 Administration Manual page 25

For example, change the Root Device value from
/dev/sda2
to
/dev/evms/sda2
Replace sda2 with the actual device on your machine.
3c Edit any device paths in the Other Kernel Parameters field.
3d Click OK to save the changes and return to the Boot Loader page.
4 Modify the failsafe image so that the failsafe root file system is mounted as /dev/evms/
instead of /dev/.
4a Select the failsafe image file, then click Edit.
4b Edit the device path in the Root Device field.
4c Check the Other Kernel Parameters field and make changes if needed.
4d Click OK to save the change and return to the Boot Loader page.
5 Click Finish.
6 Continue with Section 2.2.5, "Force the RAM Disk to Recognize the Root Partition," on
page 26.
Using a Text Editor
To edit the boot loader file in a text editor:
1 Log in as the root user or equivalent.
2 Open the boot loader file in a text editor.
For Grub, this is the /boot/grub/menu.1st file. For LILO, this is the /etc/
lilo.conf file.
3 Locate the line that contains the root= parameter.
For example, if your root file system uses device sda1, look for a line similar to this:
kernel (sd0,0)/vmlinuz root=/dev/sda1 vga=0x31a splash=silent
showopts
4 Modify the mount location from /dev to /dev/evms so it can be managed by EVMS.
For example, after the change, the line looks like this:
kernel (sd0,0)/vmlinuz root=/dev/evms/sda1 vga=0x31a splash=silent
showopts
5 Repeat Step 3 and Step 4
6 Save the file.
The changes do not take effect until the server is restarted. Do not restart at this time.
7 Continue with Section 2.2.5, "Force the RAM Disk to Recognize the Root Partition," on
page 26.
to locate other lines in the file that need to be similarly modified.
Using EVMS to Manage Devices 25