Setting E-Mail Addresses To Receive Reports With Yast; Setting The Smt Job Schedule With Yast - Novell LINUX ENTERPRISE 10 SP2 - SUBSCRIPTION MANAGEMENT TOOL GUIDE Manual

2.4 Setting E-mail Addresses to
YaST SMT Configuration module provides a comfortable interface for setting up a list
of e-mail addresses SMT reports will be sent to. To edit the list of addresses to receive
the reports, follow these steps:
1 Open the Database and Reporting tab of the YaST SMT Configuration module.
2 The list of e-mail addresses to send reports to is shown in the table. You can Add,
3 Press Finish or continue with other configurations.
The comma separated list of adresses SMT reports should be sent to is written to the
reportEmail option of the /etc/smt.conf configuration file.
2.5 Setting the SMT Job Schedule with
The YaST SMT Configuration module provides a comfortable interface to schedule
periodical SMT jobs. YaST uses cron to schedule configured jobs. If needed, cron
can be used directly. Three types of periodical jobs can be set:
Synchronization of Updates
Synchronizes with Novell Customer Center, updates catalogs, and downloads new
updates.
Report Generation
Generates and sends SMT reports to addresses defined in
mail Addresses to Receive Reports with YaST"
NCC Registration
Registers all clients to Novell Customer Center that are not already registered or
that changed their data since the last registration.
10 Subscription Management Tool Guide
Receive Reports with YaST
Edit, or Delete addresses using the respective buttons.
YaST
Section 2.4, "Setting E-
(page 10).