Interior Equipment; Case Lid; Case Bottom; Installation Of Your Printer - Dicota DataDesk 460 User Manual

User Manual DataDesk 460
Interior equipment - DataDesk 460
Interior equipment - DataDesk 460

Case lid

(Fig. 1)
(1) Document / printer paper compartment
(2) Accessory compartment with combination lock
(3) Accessory compartment
(3)
(2)
Fig. 1
Installation of your mobile printer
Installation of your mobile printer
Open your DataDesk 460.
1) Remove the flap lid from the bottom part of the case, which functions as your Notebook workspace.
2) Place the printer power supply in the front pocket of the bottom part of the case (pocket No. 6).
3) Now connect the Euro 8 plug with the 220 V socket of the power supply (in pocket No. 6).
Secure the printer power supply with the two Velcro straps!
4) Route the printer power cable through the designated groove (under the flap lid) and sideways past
the printer (Fig. 3).
Pay attention to a clean cable routing to prevent damaging the printer cable (e.g. by pinching it off)!
5) The power supply outlet plug is now connected to the printer.
Case lid
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(1)
(Fig. 2)
Fit for your printer (HP DJ 460)
Cable routing help
Stow-away pocket for CD-ROM, 3,5" FDD, etc.
Stow-away pocket for printed paper
Stow-away pocket for Notebook power supply with plug for a Euro 8-socket (with / without ground wire)
Stow-away pocket for printer power supply with plug for a Euro 8-socket (with / without ground wire)
Notebook strap
Flap lid (not seen in Fig.2)
(1)
(2)
Fig. 2
Fig. 3
(7)
(5)
(3)
(4)
(6)
(7)
7