WaterSentinel WSL-2 Installation & Quick Start Manual

Installation Quick Start Guide for WSL-2
1
Locate existing filter and remove it by turning it
counter clockwise as shown in the graphic. The
filter will eject slightly with a clicking sound.
2
Holding new filter in your hands, carefully remove
the packaging and sanitary end-cap from the
new filter.
3
Insert the new filter into the refrigerator filter
receptacle. With the handle in the vertical
position, push the new filter into the housing until
it stops. When inserting the new filter, twist the
handle slightly left to right, while pushing inward.
Rotate the filter clockwise a full 1/4 turn until you
feel it stop. Ensure filter is fully installed in
refrigerator head a full 1/4 turn. This is required
to activate the internal valve inside the
refrigerator. If the filter is not turned a full 1/4
turn the valve will not fully open and may cause
the water flow to be slow, or even cause the
valve to make a chattering noise during use.
Important Installation Instructions