• Do not operate while under the influence of medication or alcohol. • To ensure top performance keep band saw properly maintained. Contents Your Diamond Laser 5000 has been shipped partially ™ assembled. carefully remove saw and parts from the packaging. 1-Band saw Body 2-cutting Table 3-recirculating water pump and valve 4-Detachable water reservoir 5-straight edge/angle cutting Guide...
5) Fill the reservoir with 2” of water before use (approximately 3 quarts). 6) To test pump, the saw must be turned on. Be sure the blade has been properly installed and there are no obstructions to interfere with its operation and blade movement. Do noT attempt to touch the blade or blade wheels while the machine is turned on.
1) To tighten the drive belt, turn saw oFF and unplug the saw from the electrical outlet. 2) remove all screws securing rear panel encasing the motor (Fig.10).
Page 5
To adjust height of blade guide, loosen guide bar locking knob on back of saw and raise or lower the guide assembly (Fig. 18). F. Straight edge / Angle guide The band saw is designed for intricate radius cuts, however the straight edge guide will permit moderate straight edge or fixed angle cutting when needed.
3) To back out of a cut, turn the saw off and ease the material away from the blade. 4) clean band saw after each use with water. run clean water through pump until it runs clear and the water tube appears clean.
Diamond Tech offers a blade repair service should a blade break with ample diamond remaining. return blade, indicating saw model and payment to Diamond tech, Blade repair service, 5600 airport Blvd., suite C,tampa, Fl 33634. For international and special handling, please include extra postage and shipping instructions Blade Repair Fees (U.S.
Page 8
800-937-9593 or email info@dticrafts.com for a return authorization number. equipment will not be accepted at Diamond Tech without a return authorization number. if returning the Band saw for evaluation or repair, be sure to include your name, address, Daytime phone Number with Area Code and a letter explaining the specific problem you are encountering.