Table of Contents
Advertisement
Assemble the fan motor as FIG.4 – 14. Drip the glue on
1.
the "★" place of the fan motor shaft, and fix the fan on the
motor, make sure it must be fixed to the bottom of the
shaft. Attention: The fan motor shaft should not be curved,
the fan should have no abnormal stick up. After assembled,
check whether the running fan would knock the fan holder.
Assemble the fan holder as FIG.4 – 13, Then connect the
2.
power supply cord with the two wires of the fan motor, and
tighten the screws as FIG.4 – 11 and FIG.4 – 12.
Fig.4-13
1
.
1
1
T
H
E
C
A
P
A
C
I
T
1
.
1
1
T
H
E
C
A
P
A
C
I
T
Firstly, do as the 1, 2, 3, steps of Ⅲ of this part.
To disassemble,
Pull the wires of the capacitor out (4-15).
1.
Loosen and take out the screw which fix the capacitor clip
2.
with a "+" – screwdriver, and take out the clip and the
capacitor. (4-15).
To assemble,
Place the capacitor in the capacitor clip with the end which
1.
have three foot near the diode (4-16).
Insert one end of the clip in the fan holder trough (FIG.4-15).
2.
Tighten the screw, which fix the capacitor clip.
3.
Plug in all the plugs of the capacitor.
4.
1
1
.
.
1
1
2
2
T
T
H
H
E
E
D
D
I
I
O
O
D
D
E
E
.
.
Firstly, do as the 1, 2, 3, steps of Ⅲ of this part.
To disassemble,
Pull out the diode plug, which plugged in the
1.
capacitor.
Loosen the screw, which fixed the diode, and
2.
take the diode off.
To assemble,
O
R
.
O
R
.
fuse housing
fan motor
fan
Fig.4-14
capacitor
diode
magnetron
transformer
15
earthing screw
power supply cord
Fig.4-12
back board
screw
fan holder
screw
Fig.4-15
capacitor
H.V.fuse
diode
Fig.4-16
Hide quick links:
Advertisement
Table of Contents
