Glacier GPC 220 Series Installation And Service Manual

Hide thumbs

page of 17

/ 17
Bookmarks

Quick Links

Download this manual

GLACIER POOL COOLERS, LLC

OPERATOR INSTRUCTIONS,

INSTALLATION AND SERVICE MANUAL

ALL MODELS

GPC 23 THROUGH GPC 280 SERIES

GPC 23-280 SERIES

PATENT NO:

US 7,624,589 B1

MADE IN THE USA

GLACIER POOL COOLERS, LLC

P.O. BOX 5198

SCOTTSDALE, AZ 85261

PHONE: (480)272-7700

FAX: (866)276-2083

www.glacierpoolcoolers.com

Need help?

Do you have a question about the GPC 220 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Glacier GPC 220 Series

Page 1 GLACIER POOL COOLERS, LLC OPERATOR INSTRUCTIONS, INSTALLATION AND SERVICE MANUAL ALL MODELS GPC 23 THROUGH GPC 280 SERIES GPC 23-280 SERIES PATENT NO: US 7,624,589 B1 MADE IN THE USA GLACIER POOL COOLERS, LLC P.O. BOX 5198 SCOTTSDALE, AZ 85261...
Page 2 GLACIER POOL COOLERS, LLC IMPORTANT INSTRUCTIONS FOR YOUR SAFETY This product must be installed and serviced by authorized personnel, qualified in pool equipment installation. Improper installation and/or operation could cause serious injury or property damage. Improper installation and/or operation will void the warranty.
Page 3 WARRANTY INFORMATION The Glacier Pool Cooler is sold with a limited factory warranty. A copy of the warranty is included in a plastic bag inside the cooler and on the back cover of this manual. The warranty does not cover damage caused by improper installation, operation, or field modification;...
Page 4 Setting inlet and outlet lines improperly can cause large scale water loss or flooding. Special attention must be made each time cooler is operating especially after any change to pool water pressure. Glacier Pool Coolers, LLC cannot be responsible for such water loss or flooding or resulting damage.
Page 5 GLACIER POOL COOLERS, LLC PO BOX 5198 SCOTTSDALE, AZ 85261 (480)272-7700 IMPORTANT: OPERATE AND RUN YOUR POOL COOLER OVERNIGHT FOR MAXIMUM COOLING CAPACITY. A MINIMUM OF 10 TO 12 HOURS IS REQUIRED. WE DO NOT RECOMMEND OPERATING POOL COOLER DURING DAYTIME HOURS. THE HEAT FROM THE SUN AND DAYTIME TEMPERATURES WILL OVER POWER THE CHILLING PROCESS.
Page 6 These cosmetic effects will not hinder the operation of the pool cooler. Glacier Pool Coolers, LLC, however, does not warranty fan motors or pumps on salt water pools due to salt corrosion or buildup. All remaining parts are fully warranted as per our limited factory warranty.
Page 7 INSTALLATION INSTRUCTIONS GENERAL REQUIREMENTS All Glacier Pool Cooler models require correct installation to assure safe and satisfactory operation. The requirements for pool coolers include the following: 1. Appropriate site location and clearances. Cooler must be installed at least 18 inches away from buildings, walls, or fences made from material that could degrade from water exposure.
Page 8 GLACIER POOL COOLERS, LLC PO BOX 5198 SCOTTSDALE, AZ 85261 (480)272-7700 TROUBLESHOOTING EXCESS SPLATTER COMING FROM THE TOP OF THE COOLER If there is water droplets splattering out the top of the cooler you need to slow your sprinkler wands down.
Page 9 YOU MAY ALSO CONTACT OUR TECHNICAL SERVICE DEPARTMENT EMAILING ADMIN@GLACIERPOOLCOOLERS.COM CALLING 480-272-7700. Glacier Pool Coolers, LLC and Glacier Pool Coolers is a registered trademark. All other brand names, products names or trademarks belong to their respective holders.
Page 10 GLACIER POOL COOLERS PARTS FAN MOTOR FRP CASING FAN ASSEMBLY SPRINKLER WAND PVC FILLING ASSEMBLY CASING SUPPORT LOUVERS PUMP SYSTEM OUTLET LINE BASIN INLET LINE MAIN DRAIN GLACIER POOL COOLERS, LLC PO BOX 5198 SCOTTSDALE, AZ 85261 (480)272-7700...
Page 11 BASIC PARTS LIST FOR INSTALLATION PLUMBING EXISTING POOL NEW POOL BUILD PART PART 2" 2 LB. JANDY CHECK VALVES 2" 2 LB. JANDY CHECK VALVES 2" T-FITTINGS 2" T-FITTING 2" TO 1.5" REDUCERS 2" TO 1.5" REDUCER 90 DEGREE ELBOWS 90 DEGREE ELBOWS 1.5"...
Page 12 There are many different ways to WARNING electrically install a Glacier Cooler, depending on the needs of your customers. This product must be installed and serviced by authorized ELECTRICAL SHOCK HAZARD.
Page 13 Commercial pool coolers contain high voltage wiring. Contact with these wires may result in severe injury or death. Wiring errors can cause improper and dangerous operation. Glacier Pool Coolers, LLC is not responsible for improper installation or use of its equipment.
Page 14 (far left, and a little offset)if you decide to use the extra terminal for the ground wire, which is preferred. Electrical installation using an Aqualink or Compool system. Installation of a Glacier Cooler on a Back to pool Add PVC Pentair,Jandy, Hayward or a Compool is virtually the same.
Page 15 The Glacier Pool Cooler is adaptable and 4. FOURTH STEP - ELECTRICAL can be automated with ALL systems. Installation of a Glacier Cooler on a Pentair, Jandy, Hayward or a Compool is virtually the same. You need one open relay to make it work. First, find an open relay which will be feeding the 3-Way cooler and the inlet automated valve together on this relay.The relay has 4...
Page 16 Commercial pool coolers contain high voltage wiring. Contact with these wires may result in severe injury or death. Wiring errors can cause improper and dangerous operation. Glacier Pool Coolers, LLC is not responsible for improper installation or use of its equipment.
Page 17 LIMITATION OF LIABILITY: This is the only warranty given by Glacier Pool Coolers, LLC. No one is authorized to make any other warranties on Glacier Pool Coolers, LLC’s behalf. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY.

This manual is also suitable for:

Gpc 23 series Gpc 280 series