Asko 1375 Quick Start Manual page 2

Q Q Q Q Q UICK ST UICK ST UICK ST
UICK ST UICK STAR
1. Load the dishwasher. (There's no need to pre-rinse. Simply scrape off large food particles before
you load the dishware.)
2. After you've pushed the baskets back inside the unit, manually rotate the upper and lower spray
arms to be sure they turn freely.
3. Make sure there is rinse aid in the dispenser. Add rinse aid, if needed.
4. Add automatic dishwashing detergent and close the dispenser cover. (See "Amount of
Dishwashing Detergent to Use" on the other side of this Quick Start Guide .)
5. Close the door securely.
6. Set the Temp boost and Heated dry options as desired.
7. Turn the control knob to the desired program. The dishwasher will start.
ENERGY SA ENER ENER GY SAVING GY SA GY SA VING VING TIPS VING
ENER ENER GY SA VING
Don't pre-rinse. Simply scrape off large food particles before you load the dishes.
Wash only full loads.
Don't use the high wash temperature for lightly soiled dishes.
Avoid using Heat dry. (You can speed up the drying process by opening the door slightly to release the moist air.)
COMMONL COMMONLY Y Y Y Y ASKED Q COMMONL ASKED Q ASKED Q
COMMONL COMMONL ASKED QUESTIONS ASKED Q
1) Where do I put the prewash detergent?
2) Where do I put the rinse aid?
3) Why does my dishwasher run so long?
4) Why am I getting a white film on my dishes?
5) Why is there always water left in the bottom of my
machine?
AR AR T PR T PR OCEDURES OCEDURES
AR ART PR T PROCEDURES T PR OCEDURES OCEDURES
TIPS TIPS TIPS
TIPS
UESTIONS UESTIONS
UESTIONS UESTIONS
Refer to your Use and Care Guide for additional information.
ANSWERS ANSWERS
ANSWERS ANSWERS ANSWERS
1) The prewash detergent goes in the small compartment
between the main wash detergent compartment and the rinse
aid dispenser. (See page 4.)
2) The rinse aid goes into the rinse aid dispenser. (See page 5.)
3) If the temperature of the water entering your dishwasher is
below 120°, the dishwasher runs longer because it heats the
water to the proper temperature for the program selected.
Raising your water heater setting may help shorten the cycle
times. If this doesn't resolve the problem, call the ASKO
Advisory Center.
4) You may be using too much detergent or washing your dishes
in water that is too hot. Try using less detergent and a lower
temperature setting. (See pages 5 and 8.)
5) It's normal to have some water left in the sump area near the
drain. If the water fills more than the drain area, see page 9 for
possible solutions.
Refer to this page in
the Use & Care Guide .
3, 4
3
5, 6
4, 5