Page 3
HikDashcam AE-DC2032-V300 User Manual C Packing List Dashcam × 1 4-Lead Hardware Kit Power Cable × 1 Rear Camera × 1 and Connector Cable × 1 User Manual × 1 Accessory Package × 1 Eject Pin × 1 Electrostatic Sticker × 1...
Page 4
HikDashcam AE-DC2032-V300 User Manual D Parts Introduction 3M Adhesive Pad Lens USB Interface Note: USB interface is for power supply only. Rear Camera Port Eject Pin Hole of MicroSD (TF) Slot Speaker 4G / GPS Indicator and Power Indicator Figure 1, Left View *Check the 4G/GPS silk screen printing according to the actual selection.
Page 5
HikDashcam AE-DC2032-V300 User Manual E Install Dashcam Figure 4, Route Cable to Fuse Box Figure 3, Apply Electrostatic Sticker Clean the windshield and paste the electrostatic Paste the device onto the electrostatic sticker sticker onto the windshield. and route cable to the fuse box for power.
HikDashcam AE-DC2032-V300 User Manual F Install Rear Camera OPTION 1: Exterior Mounting Peel off the adhesive release paper on the camera bracket. Install the camera centered directly above the license plate so that it points at the road. Connect the rear camera to the front dashcam by routing the cable as per the following diagram:...
HikDashcam AE-DC2032-V300 User Manual F Install Rear Camera OPTION 2: Interior Mounting Peel off the adhesive release paper on the camera bracket. Install the camera onto the top center of the rear window (interior side) so that it points directly at the road.
Page 8
Edit the dashcam password to activate to avoid abnormal recording after connecting the Wi-Fi. Dashcam Wi-Fi default parameters: • Wi-Fi SSID: hikvision-xxxx-xxxx (xxxx refers to the last four verification code characters). • Wi-Fi password by default is 1234567890 • Create a new password after first login.
HikDashcam AE-DC2032-V300 User Manual H Basic Operations Recording Power on the dashcam and start to recording . · Auto capture: When the car is hit or shaken, the dashcam senses vibrations and captures the current video. · Manual capture: Press snapshot button to capture the current picture. To associate with the current video, it needs to be set up in the app.
HikDashcam AE-DC2032-V300 User Manual J Cautions Safety Instructions These instructions are intended to ensure that users can use the product correctly to avoid danger or property loss. Cautions Injury or equipment damage may occur if any of the cautions are neglected.
HikDashcam AE-DC2032-V300 User Manual K Troubleshooting Trouble Solution • Clean the windshield before installation. The dashcam falls off easily • Check that the 3M adhesive pad is tightly adhered to the electrostatic film before installation. • Check whether the vehicle is started and the power supply is normal.
Page 13
HikDashcam AE-DC2032-V300 User Manual K Troubleshooting • Check interference from surrounding Wi-Fi signals. Use the dashcam in an environment where there is less interference. Connecting to Wi-Fi takes a long time Shut down unnecessary programs and apps on your phone to release •...
Need help?
Do you have a question about the HikDashcam AE-DC2032-V300 and is the answer not in the manual?
Questions and answers