Installation And Setup; Setting Up The Unit; The Unit Connection - LG LH-E922PB Owner's Manual

Installation and Setup

Setting up the unit

The picture and sound of a nearby TV, VCR, or radio
may be distorted during playback. If this occurs,
position the unit away from the TV, VCR, or radio, or
turn off the unit after removing the disc.

The unit Connection

Depending on your TV and other equipment there are
various ways you can connect the unit. Please refer to
the manuals of your TV, stereo system or other
devices as necessary for additional connection
information.
MONITOR
COAXIAL IN AUX IN
OUT
R - AUX - L
Y P P
B R
COMPONENT VIDEO OUT
i Pod
XM IN
C
Y
COMPONENT VIDEO /
PROGRESSIVE SCAN INPUT
Rear of TV
Video Connections to Your TV
Make sure the unit is connected directly to the TV and
not to a VCR, otherwise the DVD image could be
distorted by the copy protection system.
Connect the MONITOR OUT jack on the unit to the
video in jack on the TV using the video cable (V).
Notes:
• For MONITOR OUT jack connection, resolution
must be set to 480i or 480p by pressing RESOL. on
the Remote Control, however MONITOR OUT is
always at 480i standard resolution.
• HDMI mode must be set to OFF for VIDEO OUT
jack connection.
Component Video (ColorStream
Connect the COMPONENT VIDEO OUT jacks on
the unit to the corresponding jacks on the TV
using a Y P
• If your television is a high-definition or "digital
ready" television, you may take advantage of the
unit's progressive scan output for the highest
video resolution.
• If your TV does not accept your resolution
setting, abnormal picture appears on the screen.
Please read owner's manual for TV then set the
resolution that your TV can accept.
Notes:
• You can change the resolution (480i, 480p, 720p,
1080i) for the COMPONENT VIDEO OUT by
pressing RESOL. on the Remote Control.
• For 720p and 1080i resolution, only non-copy
protected discs can be played back. If the disc is
copy protected, it will be displayed at the 480p
resolution.
The resolution (720p, 1080i) is for the component
and HDMI outputs only.
• The HDMI mode must be set to OFF for Component
video connections.
V
• The resolution (720p, 1080i) does not work with the
analog video connections (VIDEO OUT).
L
VIDEO
INPUT
connection
® )
P cable (C).
B R
11