Splendide WDC7200XCD Quick Manual

COMBO QUICK GUIDE
Laundry Aid
Laundry Aid
Dispenser
A
4
Dispenser
1
2
3
Chamber 1:
Prewash detergent* (powder
ONLY)
Chamber 2:
Powder or liquid HE
detergent* (Move plastic
partition to slot A when using
liquid or store in slot B when
using powder.)
Chamber 3:
1-2 Tbsp. fabric softener
Extra Chamber 4:
Bleach
IMPORTANT!
*Use only High
Efficiency (HE)
detergent in the correct
dosage for your
machine (1-2 TBSP of
powder detergent (or
liquid equiv.) per load.
Chamber 1:
Prewash detergent* (powder
ONLY)
Chamber 2:
Powder or liquid HE
detergent* (Move plastic
partition to slot A when using
liquid or store in slot B when
using powder.)
Chamber 3:
1-2 Tbsp. fabric softener
Extra Chamber 4:
Bleach
IMPORTANT!
*Use only High
Efficiency (HE)
detergent in the correct
dosage for your
machine (1-2 TBSP of
powder detergent (or
liquid equiv.) per load.
>>>
Before using your combo for the first time, run a
Using your new Splendide combo is easy!
Laundry Aid Dispenser
1
Press ON.
The symbols on the display will light.
Load the drum. Be sure the laundry
has been sorted by fabric color/type
and all pockets are empty. When
drying, do not overload the drum.
Full to
WASH
1/2 Full to
DRY
Load the dispenser (See left).
SEE BACK PAGE FOR 'CLEAN WASHER' AND 'WINTERIZATION' INSTRUCTIONS
3
2
SELECT A
CYCLE
Select a wash or dry cycle.
optimal spin and temperature settings
for that cycle will be shown on the
display.
Press the Timed Dry
Select a dry time.
button until the desired time is shown
on the display. (WDC7200XCD ONLY
- Iron Dry will stop automatically when
4 clothes are still damp).
Use buttons to customize the cycle.
Any spin and temperature settings you
modify will be saved and preselected
the next time the wash cycle is used.
1
2
'Clean Washer' cycle (see back page) .
Display
Spin +
Wash Rinse
Hot Drai n
Super
Wash
DISPLAY
Timed
Dry
Cold Slow Fast
Spin Delay Low
Temp.
Speed Start Heat
(Iron Dry -
WDC7200XCD)
The Press and HOLD the START button
for 2 seconds, then release it.
A
will indicate the cycle is accepted.
NOTE: Your washer uses state-of-the-art
safety and performance technologies.
Water will enter the drum AFTER
certain load criteria have been
measured and met (up to 2 minutes).
To pause the cycle
PAUSE button once. To unpause, press
and hold 2 seconds, then release.
To cancel the cycle
ON/OFF button. The cycle will stop, any
water will drain, and the machine will
shut off.
Q R- C
WDC7200XCD / WDV2200XCD
1
Pre
Wash
3
A BEEP
tap the START/
Press and hold the
> > >