Page 1
WITH BUILT-IN DVD PLAYER LT-32C485 Thank you for purchasing your new JVC TV. Your new TV incorporates the latest technology to enhance your viewing experience. We would suggest that you allow about 20 mins for initial setup. Please follow this guide for a successful first time installation.
Page 2
Unpacking Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to any local regulations. ASPECT REPEAT LIST AUDIO GUIDE MENU INPUT DVD SETUP BACK EXIT PROG STEP GOTO INDEX HOLD REVEAL SIZE MENU ANGLE...
Operating Your Remote Control 1. Press and lift the back cover to open the battery compartment of the remote control. 2. Insert two AAA size batteries. Close the battery compartment cover. Install the batteries correctly by following the polarity (+ and -) indications in the battery compartment.
Installing the Base Stand 1. Lay the TV down on a flat surface with the back side facing up, and ideally at the edge of a table so that the base of the TV slightly overhangs on it. Please make sure a soft cushioned material (such as a pillow or thick piece of foam) is placed beneath the screen. 2.
Page 5
Connecting the Aerial and the Mains Socket 1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the RF (75 ) socket at the rear right bottom of your TV.
Page 6
Turning the TV On for the First Time If you are going to watch TV using a set-top box, press the EXIT button on the remote control then skip this section. Then press the INPUT button on the remote control to select HDMI mode.
TV. If after reading the instruction manual you have additional questions related to the use of your TV please call: • UK Call Centre on 0344 561 1234. • Ireland Call Center on 1 890 818 575. (QSG-LT-32C485-180406V2)
Need help?
Do you have a question about the LT-32C485 and is the answer not in the manual?
Questions and answers