Red Hat NETWORK PROXY 5.3.0 Installation Manual page 41

Hide thumbs Also See for NETWORK PROXY 5.3.0:
Table of Contents

Advertisement

15. In the Configure Monitoring page, provide or confirm the hostname and IP address of the parent
server connected to by the RHN Proxy Server. This must be either an RHN Satellite Server or
another Proxy which is in turn connected to a Satellite. You cannot achieve Monitoring through the
central RHN Servers. When finished, click continue. The Install Progress page appears.
Figure A.8. Install Progress
16. In the Install Progress page, you may monitor the steps of the installation as they take place.
Click the link to any step to go to its Action Details page. When an action begins, its status goes
from Queued to Picked Up and then finally to Completed. Like the earlier package installs,
you can immediately trigger these steps by running the rhn_check command in a terminal on
the system as root. When finished, the Install Progress page will display the message The
installation is complete. You may now begin registering systems to be served by the
RHN Proxy Server. Refer to the RHN Client Configuration Guide.
17. When all items on the Install Progress page are Completed, the Proxy is ready for use. You can
now register systems to RHN through the Proxy.
37

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NETWORK PROXY 5.3.0 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents