Red Hat NETWORK 2.9 - MANAGEMENT Reference Manual page 60

52
Figure 4-4. System Group List
The System Groups list contains several columns for each group:
Select — Enables you to add groups to the System Set Manager. To select groups, mark the
•
appropriate checkboxes and click the Update button below the column. Selected groups are added
to the System Set Manager. After adding groups to the System Set Manager, you can use it to
perform actions on them simultaneously. To add an intersection of groups, select them and click the
Work with Intersection button. To add a union of groups, select them and click the Work with
Union button. Refer to Section 4.4.4 System Set Manager for details.
Status — Shows which type of Errata Alerts are applicable to the group or confirms that it is up-
•
to-date. Clicking on a group's status icon takes you to the Errata tab of its System Group Details
page. Refer to Section 4.4.3.3 System Group Details for more information.
The status icons call for differing degrees of attention:
— All systems within group are up-to-date
•
— Critical Errata available, update strongly recommended
•
— Updates available and recommended
•
Group Name — The name of the group as configured during its creation. The name should be
•
explicit enough to easily differentiate between it and other groups. Clicking on the name of a group
takes you to Details tab of its System Group Details page. Refer to Section 4.4.3.3 System Group
Details for more information.
Systems — Total number of systems contained by the group. Clicking on the number takes you to
•
the Systems tab of the System Group Details page for the group. Refer to Section 4.4.3.3 System
Group Details for more information.
Use in SSM — Clicking the Use Group button in this column loads the group from that row and
•
launches the System Set Manager immediately. Refer to Section 4.4.4 System Set Manager for
more information.
Chapter 4. Red Hat Network Website