SAFETY INFORMATION Thank you for purchasing this product (SWA-9200S). CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). NO USER- SERVICEABLE PARTS ARE INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Page 3
• The slots and openings in the cabinet and in the back or bottom are provided for necessary ventilation. To ensure reliable operation of this apparatus, and to protect it from overheating, these slots and openings must never be blocked or covered. •...
Page 4
• Be sure to pull the power plug out of the outlet if the product is to remain unused or if you are leaving the house for an extended period of time (especially when children, elderly, or disabled people will be left alone in the house).
Page 5
CAUTION (for Canada) This device contains licence-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Important Safety Instructions Read these operating instructions carefully before using the unit. Follow all the safety instructions listed below. Keep these operating instructions handy for future reference. 1. Read these instructions. 2. Keep these Instructions. 3. Heed all warnings. 4. Follow all instructions. 5.
Page 7
(Label: Rear of the Main Unit) • Design and specifications are subject to change without prior notice. 02 CONNECTING THE SWA-9200S TO A SOUNDBAR 1. Connect the Surround speaker cables Use the speaker cables to connect the two surround sound speakers.
Page 8
2. Turn on the Surround speakers Plug the Surround speakers’ power cord into an electrical outlet to turn on the Surround speakers. The LINK LED indicator(blue LED) on the rear of left surround speaker will blink quickly. If the LINK LED does not blink, please see step 6. LINK STANDBY ID SET Rear of Left...
Page 9
4. Connect Soundbar and Surround Speakers Press the Up button on the remote control for more than 5 seconds until the “ID SET” message appears on the Soundbar’s display. The message will disappear shortly. (If your Soundbar does not have a display window and only LED indicators, please refer to the LED information below.) •...
Page 10
2. Repeat steps 3 through 5. STANDBY (Red) On : When the Soundbar turns off or connection has failed. • Follow the instructions for “Link (Blue) Blinking slow (at an interval of around 1 second)” above. Others : Errors • Contact a Samsung Service Center.
• Please change the TV network connection status from wireless to wired. The volume of Surround Speakers is too low • Please increase the rear level referring to the manual of your Soundbar. (You can download the manual of your Soundbar from www.samsung.com/support)
• Be sure the wall is stable. If the wall is weak, reinforce it before installation. • Take care not to install the speakers sideways or upside down. • Samsung Electronics is not liable for any damage to the product due to improper installation. • Wall mounts aren’t sold by Samsung Electronics.
50 ℉ to 104 ℉ non-condensing (10 ℃ to 40 ℃) AMPLIFIER Rated Output power 60 W x 2 NOTE • Samsung Electronics Co., Ltd reserves the right to change the specifications without notice. • Weight and dimensions are approximate.
Page 14
LIMITED WARRANTY TO ORIGINAL PURCHASER Samsung Electronics Canada Inc.(SECA), warrants that this product is free from defective material and workmanship. SECA further warrants that if this product falls to operate properly within the specified warranty period and the failure is due to improper workmanship or defective materials, SECA will repair or replace the product at its option.
Need help?
Do you have a question about the SWA-9200S and is the answer not in the manual?
Questions and answers