Related Manuals for Scrib3D P1
Summary of Contents for Scrib3D P1
- Page 1 User Manual Scrib3D P1 For the best user experience, please read this manual completely before usage. www.Scrib3Dpen.com...
- Page 2 W A R N I N G S - The Nozzle of the Scrib3D P1 can become hot. DO NOT touch the Nozzle, or you may be burned! - DO NOT allow the Nozzle near or in contact with flammable materials.
-
Page 3: Product Overview
Product Overview Features and Controls of your Scrib3D P1 3D Pen FILAMENT POWER LOADER LED: TEMPERATURE POWER ADJUSTER INDICATOR SCREEN SPEED ADJUSTER LED: TEMPERATURE INDICATOR REVERSE FORWARD P1 3D pen Power Adapter Filament (5V 2A) -
Page 4: Getting Started
Getting Started 1. Connect the AC Adapter to an outlet. Plug the AC Adapter Plug into the Power Socket of the pen. The power indicator light should become yellow. (Note: this 3D pen can be used with a 3rd party power bank with at least 2 Amps output) 2. - Page 5 Wall outlet DC 5V/2A The Display will ash either ABS or PLA until the Forward Button is pressed to chose a mode. Then the screen will Show desired temperature and current temperature. The temp LED will remain red while the pen is heating up.
- Page 6 When using your Scrib3D P1 3D Pen you will nd the best results for drawing at object and on surface from holding the pen at an angle of 65 dagrees or higher. Snip those tips! when you change plastic or before you insert a new strand make sure the lament has a at surface so it can push the previous lament.
- Page 7 Temperature Tuning 1. If when using the pen you see the plastic bubbling or you hear a crackling noise coming from the plastic your temperature might be too high. Try lowering it 5~10°C and see if that helps. 2. Filament should come out smooth and with out much bubbling but it is normal to have some small bubbling.
-
Page 8: Troubleshooting
Troubleshooting Here are some common problems and possible solutions to these issue. If you can’t resolve the issue please reach out to our customer service by email us at help@Scrib3Dpen.com Problem Reasons Solution Issue with the AC adapter Replace the AC adapter or plug with another: 5v, 2A, 3.8mm Power indicator... - Page 9 Made in China, Guangdong. CARE & MAINTENANCE For care and maintenance information, and more advice on how to use your Scrib3d P1, please refer to our website: Scrib3dPen.com To troubleshoot, please visit: Scrib3dPen.com/troubleshooting SPECIFICATION OF POWER ADAPTER Input: 100-240V AC, 0.35A MAX, 50-60Hz Output: +5V DC, 2A...
- Page 10 ISSUES? Before returning to the retailer see if we can help Check out our tutorials: SCRIB3dPen.com/tips Need more help? Contact us help@SCRIB3dPen.com...
Need help?
Do you have a question about the P1 and is the answer not in the manual?
Questions and answers