LAMAX BCool Operating Instructions

Charging the watch
Fully recharge the watch before using it for the first time. Plug the included
power cord into a USB charger or USB port on your computer, attach the pins
to the tabs on the bottom of the watch, and attach the power cord to the
watch with the magnets. The display shows the charging status information
when the charger is connected. The entire battery will be charged in appro-
ximately 2 hours.
Controls
You can control the watch by moving your wrist or touching it. Turning your
wrist to a horizontal position activates the watch display, showing the time
and other information depending on the selected watch dial (e.g., number of
steps, date, battery status, etc.). You can enable or disable the watch being
activated by turning your wrist in the mobile application.
Control the following actions by pressing the side button or touching
the watch display
Action
Turning on the watch
Turning off the watch
Turning on the display
Navigating
Status bar and quick
settings
Confirm selection
Return
EN
BCool
Operating Instructions
Gesture
Press and hold the side button.
Press and hold the side button, or on the lit display,
swipe right to the watch menu, selecting the icon
labelled "Settings" on the third page. Then touch the
icon labelled "System. " A list will open where you
should touch the icon labelled "Off" and confirm the
selection by touching the green button.
Press the side button or turn your wrist to a
horizontal position.
Swipe right or left on the screen or up and down if
there is a list.
Swipe your finger from top to bottom on the screen
while the dial is displayed.
Touch the screen.
Press the side key.