Red Hat ENTERPRISE LINUX 4 - INSTALLATION GUIDE FOR IBM S-390 AND IBM ESERVER ZSERIES Installation Manual page 46

Chapter 2. Installing Red Hat Enterprise Linux
You must select a language to use as the default language. The default language is the
language used on the system once the installation is complete. Typically, the default language
is the language you selected to use during the installation.
If you choose to install other languages during this installation, you can change your default
language after the installation. If you are only going to use one language on your system,
selecting only that language saves significant disk space.
Caution
If you select only one language, you can only use that specified language after
the installation is complete.
Figure 2.12. Language Support Selection
To use more than one language on your system, choose specific languages to be installed or
select all languages to have all available languages installed on your Red Hat Enterprise Linux
system.
Use the Reset button to cancel your selections. Resetting reverts to the default; only the
36