Installing Via Http - Red Hat ENTERPRISE LINUX 4 - INSTALLATION GUIDE FOR IBM S-390 AND IBM ESERVER ZSERIES Installation Manual
Installation guide for the ibm s/390 and ibm eserver zseries architectures
Hide thumbs
Also See for ENTERPRISE LINUX 4 - INSTALLATION GUIDE FOR IBM S-390 AND IBM ESERVER ZSERIES:
- Installation manual (58 pages)
Table of Contents
Advertisement
Chapter 2. Installing Red Hat Enterprise Linux
mount -o loop example-1.iso discX
4.4. Installing via HTTP
The HTTP dialog applies only if you are installing from an HTTP server (if you selected HTTP in
the Installation Method dialog). This dialog prompts you for information about the HTTP server
from which you are installing Red Hat Enterprise Linux.
Enter the name or IP address of the HTTP site you are installing from, and the name of the
directory containing the
installation files for your architecture. For example, if the HTTP
RedHat/
site contains the directory
, enter
/mirrors/redhat/arch/RedHat/
/mirrors/redhat/arch/
(where
is replaced with the architecture type of your system, such as i386, ia64, ppc, or
arch
s390). If everything was specified properly, a message box appears indicating that
is being retrieved.
base/hdlist
Figure 2.5. HTTP Setup Dialog
Next, the Welcome dialog appears.
22
Advertisement
Table of Contents
Need help?
Do you have a question about the ENTERPRISE LINUX 4 - INSTALLATION GUIDE FOR IBM S-390 AND IBM ESERVER ZSERIES and is the answer not in the manual?
Questions and answers