Installing In An Lpar (Common Steps); Do You Have Enough Disk Space - Red Hat ENTERPRISE LINUX 3 - INSTALLATION GUIDE FOR IBM S-390 AND IBM ESERVER ZSERIES Installation Manual

8
Host Computer:
Hostname or IP address of the FTP server you wish to install from (for example,
ftp.redhat.com
User ID:
Your user name on the FTP server (or anonymous)
Password:
Your password (use your email address if you are logging in as anonymous)
Account:
Leave this field empty
File location (can be left blank):
Directory on the FTP server holding Red Hat Enterprise Linux for S/390 (for example,
/pub/redhat/linux/rawhide/s390
Click Continue.
•
In the dialog that follows, keep the default selection of
•
Refer to Section 1.8 Installing in an LPAR (Common Steps) to continue.
•

1.8. Installing in an LPAR (Common Steps)

Once the Red Hat Enterprise Linux installation program has started (if the red field behind the LPAR
icon is disappearing, the installation program has begun), select the LPAR and double-click on Oper-
ating System Messages.
The initial installation start-up script asks you questions about your networking and DASDs unless
you have specified all necessary information in the
Once all questions have been answered, you are ready to begin the core installation program, loader.
To continue with the installation, refer to Chapter 2 Installing Red Hat Enterprise Linux for further
instructions.
Note
If you install over a network with FTP or HTTP you must perform a text mode installation.

1.9. Do You Have Enough Disk Space?

Nearly every modern-day operating system (OS) uses disk partitions, and Red Hat Enterprise Linux is
no exception. When you install Red Hat Enterprise Linux, you may have to work with disk partitions.
The disk space used by Red Hat Enterprise Linux must be separate from the disk space used by other
OSes you may have installed on your system.
For more information about disks and partition configuration, refer to Section 2.12.4 Recommended
Partitioning Scheme.
)
Chapter 1. Steps to Get You Started
)
redhat.ins
file.
lpar.parm
and click Continue.