Installing In An Lpar Using The Red Hat Enterprise Linux Lpar Cd; Installing In An Lpar Without The Red Hat Enterprise Linux For S/390 Cd-Roms - Red Hat ENTERPRISE LINUX 3 - INSTALLATION GUIDE FOR IBM S-390 AND IBM ESERVER ZSERIES Installation Manual

Chapter 1. Steps to Get You Started
/* */
'CL RDR'
'PURGE RDR ALL'
'SPOOL PUNCH * RDR'
'PUNCH KERNEL IMG A (NOH'
'PUNCH REDHAT PARM A (NOH'
'PUNCH INITRD IMG A (NOH'
'CH RDR ALL KEEP NOHOLD'
'IPL 00C CLEAR'
The initial installation start-up script prompts you for information about your networking and DASDs
unless you have specified all necessary information in the
Once all questions have been answered, you are ready to begin the core installation program, loader.
To continue with the installation, refer to Chapter 2 Installing Red Hat Enterprise Linux for further
instructions.
Note
If you install over a network with FTP or HTTP you must perform a text mode installation.

1.6. Installing in an LPAR using the Red Hat Enterprise Linux LPAR CD

The following steps must be taken when installing Red Hat Enterprise Linux onto an LPAR.
Log in on the Support Element Workplace (SEW) (some older versions of the SEW are called
•
Hardware Management Consoles) as a user with sufficient privileges to install a new OS to an
LPAR. The SYSPROG user is recommended.
Select Images, then select the LPAR to which you wish to install. Use the arrows in the frame on
•
the right side to navigate to the CPC Recovery menu.
Double-click on Load from CD-ROM or Server.
•
In the dialog box that follows, select Local CD-ROM then click Continue.
•
In the dialog that follows, keep the default selection of
•
Skip to Section 1.8 Installing in an LPAR (Common Steps) to continue.
•
1.7. Installing in an LPAR without the Red Hat Enterprise Linux for
S/390 CD-ROMs
Log in on the Support Element Workplace as a user with sufficient privileges to install a new OS to
•
an LPAR.
Select Images, then select the LPAR you wish to install to.
•
Use the arrows in the frame on the right side to navigate to the CPC Recovery menu.
•
Double-click on Load from CD-ROM or Server.
•
In the dialog box that follows, select FTP Source, and enter the following information:
•
file.
parm
then click Continue.
redhat.ins
7