Configuring Single-Master Replication; Configuring The Read-Write Replica On The Supplier Server - Red Hat DIRECTORY SERVER 8.0 - ADMINISTRATION Administration Manual

Chapter 8. Managing Replication
dn: cn=replication manager,cn=config
objectClass: inetorgperson
objectClass: person
objectClass: top
cn: replication manager
sn: RM
userPassword: password
passwordExpirationTime: 20380119031407Z
Example 8.1. Example Supplier Bind DN Entry
When configuring a replica as a consumer, use the DN of this entry to define the supplier bind DN.

8.4. Configuring Single-Master Replication

To set up single-master replication such as the configuration shown in
Replication", between supplier Server A, which holds a read-write replica, and the two consumers
Server B and Server C, which each hold a read-only replica, there are two major steps:
Section 8.4.1, "Configuring the Read-Write Replica on the Supplier Server"
•
Section 8.4.2, "Configuring the Read-Only Replica on the Consumer"
•
Section 8.4.3, "Create the Replication Agreement"
•

8.4.1. Configuring the Read-Write Replica on the Supplier Server

1. Specify the supplier settings for the server.
a. In the Directory Server Console, select the Configuration tab.
b. In the navigation tree, select the Replication folder.
c. In the right-hand side of the window, select the Supplier Settings tab.
236
Figure 8.1, "Single-Master