Related Manuals for Simu WINDY HZ ACCEL
Summary of Contents for Simu WINDY HZ ACCEL
- Page 1 Ref. 5117134A WINDY HZ ACCEL FR - Notice d’installation EN - Installer Manual DE- Installationsanleitung www.simu.com...
- Page 2 être enfermé dans la barre de ch support (voir Caractéristiques techniques, fi gure F). Attention : Le Windy Hz Accel ne - Fixer le support : la fl èche gravée sur le support doit ÉLÉMENTS être orientée pointe vers le haut.
-
Page 3: Montage
- Remove the sensor from its casing using a fl at ver be headphones) with a transmission frequency ide t sets the detection of screwdriver. to the Windy Hz Accel can affect its function. values pre-set in the - Insert the AAA batteries provided into the sensor, en the... - Page 4 - Drücken Sie einmal lange (7 Sekunden) auf die PROG Taste so lange, bis die Markise automatisch einfährt. Der Sensor ist neu eingestellt und aktiv. - Ersetzen Sie die AAA-Alkali Sensors bestätigt. Der Windy Hz Accel ist nun nlernen des eines im Markisenantrieb eingelernten Sensors bis der Antrieb zwar - Der Sensor ist nun eingestellt und schaltet in den Dem 7.
- Page 5 The detection of shaking corre- sponds to a sensitivity threshold. The Windy Hz Accel has been designed for terrace awnings with arms, such as canopy, box or cassette awnings. The Windy Hz Accel is compatible with Hz motors (Hz.02, DMI Hz, ESP Hz), Hz remote controls...
-
Page 6: Description Of The Parts
4. INSTALLATION • Installation recommendations ☛ SEE ILLUSTRATION B The Windy Hz Accel is fi xed to the load bar, either at the ends or in the middle. Shaking is more easily detected at the ends. Caution! The Windy Hz Accel must never be enclosed in the load bar. -
Page 7: Technical Characteristics
☛ SEE ILLUSTRATION C Caution! The adhesive supplied is only to be used for this operation. Always use the adhesive delivered by Simu. The use of any other adhesive is forbidden. - Position the support on the inside surface of the load bar;... - Page 8 ( < 1 s.) on the Windy Hz Accel sensor until the awning does a short up and down movement: the Windy Hz Accel sensor is programmed in the memory of the motor. • Adjustment to a pre-defi ned threshold ☛...
-
Page 9: Method Of Operation
Caution! If the cover & sensor assembly is disengaged from the support for more than 4 seconds, re-engage it and then repeat the two previous steps. - Shake the awning to simulate the maximum level of vibration permitted, until the awning rises automatically: the sensor is set. - Page 10 • Problem solving PROBLEME CAUSE ACTIONS The LED does not The batteries are Check the direction come on after the incorrectly fi tted. in which the batteries batteries have been are inserted into the inserted. sensor. The sensor is not Program the sensor programmed into the into the motor...
- Page 11 Tel. 00 33 (0) 3 84 64 75 00 Fax 00 33 (0) 3 84 64 76 21 FR - Par la présente, SIMU déclare que le produit est conforme aux exigences essentielles et aux autres dispositions pertinentes de la directive 2006/42/CE. Une déclaration de conformité...
Need help?
Do you have a question about the WINDY HZ ACCEL and is the answer not in the manual?
Questions and answers