Sealey PT500.V3 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS &
CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO
SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE
FOR FUTURE USE.
Refer to
instructions
1. SAFETY
IMPORTANT: before operating the trolley, ensure you have read and
understood all instructions in this manual.
Keep trolley and beams in good working order and condition.
9
It is necessary to carry out a risk assessment to avoid injury due to over intensive use.
9
Follow the inspection and examination requirements as described in 'Maintenance'.
9
Take immediate action to repair or replace damaged parts by contacting your supplier.
9
Ensure that all accessory lifting devices are suitably certified. If damaged, remove
9
from service immediately.
Ensure there is adequate space for operating the trolley. Perform a risk assessment
9
of the area.
The trolley is designed to travel on a level beam/gantry.
9
The maximum longitudinal slope of the travelling surface is 0.3%.
9
The trolley is designed to carry a load up to the rated capacity.
9
Be aware of centre of gravity for different equipment and operating configurations.
9
WARNING! The capacity indicated on the trolley (see nameplate) is the maximum safe working load which must not be exceeded.
‰
Keep children and unauthorised persons away from the working area.
9
Keep working area clean and tidy, free from unrelated materials and ensure that there is adequate lighting.
9
Ensure that load does not exceed the maximum capacity of the trolley. Overloading the trolley is dangerous.
9
Where appropriate, use only the lifting points recommended by the manufacturer of the item to be lifted, e.g. vehicle engine.
9
Ensure that load does not exceed the maximum capacity of the I Beam that the trolley is attached to.
9
Before lifting the load ensure that there are no obstacles which may snag the load whilst it is being lifted.
9
To avoid injury, be fully aware of your own and other persons locations in relation to the lifting, and lowering, of the load.
9
Keep a sound footing and balance, and ensure the floor is not slippery.
9
DO NOT harness the load at an angle or use any attachments not verified as fit for purpose.
8
DO NOT allow the load to swing during lifting.
8
Lower load with care, ensuring that you are fully aware of the condition of the surface onto which the load is to be placed.
9
DO NOT position any part of your body beneath the load.
8
DO NOT use this product to perform a task for which it is not designed.
8
DO NOT use whilst under the influence of drugs, alcohol or intoxicating medication.
8
DO NOT lift or transport loads while personnel are in the danger zone.
8
DO NOT allow personnel to pass under a suspended load.
8
DO NOT use the trolley for transportation of people.
8
DO NOT use the trolley in explosive or corrosive environments.
8
DO NOT use wheels with cylindrical tread on tapered flanges.
8
In the event of an accident or breakdown, DO NOT use.
8
After lifting, DO NOT leave the load suspended for longer than necessary.
8
Start moving the load only after it has been attached correctly and all personnel are clear of the danger zone.
9
When the load prevents adequate visibility of the zone in front of the load, there is a necessity to be assisted.
9
When not in use, store in a safe, dry, childproof area.
9
This trolley is designed for use within a garage or workshop environment, ambient operating temperature between - 10°C and + 50°C.
9
The Sound Pressure of this product is less than 70dB(A)
9
In the event of an emergency, accident or breakdown, stop using the trolley. Make provisions for safely lowering the load. Perform
9
inspection and examination requirements before reuse.
Perform safety checks when restarting after an intervention.
9
WARNING! Failure to heed safety and warning instructions may result in damage and/or personal injury, and will invalidate the warranty.
‰
© Jack Sealey Limited
0.5 TONNE PLAIN TROLLEY
PT500.V3
MODEL NO:
Original Language Version
Washers
Hanger Pin
Wheels
PT500.V3 Issue 3
Side plates
19/12/2024