Table of Contents
Advertisement
Appendix
To add host entries to the NetLinx URL list:
1. Open a terminal session (via TELNET or SERIAL) to the NetLinx Master.
2. Type "echo on", and press the ENTER button.
3. Type "url list" , and press the ENTER button.
If no URL's are in your NetLinx Master, it returns the following response:
"No URLs in the URL connection list"
To add a URL:
1. Type "set url", and press the ENTER button.
The NetLinx Master should return:
No URLs in the URL connection list
"Type A and Enter to Add a URL or Enter to exit. ->"
2. Type "A", and press the ENTER button.
The NetLinx Master should return:
"Enter URL ->"
This is where you enter the IP Address of the i!-PCLink/Media Player Host Computer.
3. Type "192.168.1.1", and press the ENTER button. (Replace 192.168.1.1 with your IP
Address).
The NetLinx Master should return:
"192.168.1.1" (Your IP Address)
"Enter Port or hit Enter to accept default (1319) ->"
4. Press the ENTER button to accept the default port (1319).
The NetLinx Master should return:
"Enter Type (Enter for permanent or T for temporary) ->"
5. Press the ENTER button to make the entry permanent.
The NetLinx Master should return:
"URL Added successfully."
"Type A and Enter to Add a URL or Enter to exit. -> "
6. Press the ENTER button to exit.
To make sure the entry was made, or to check the status of the link:
Type "url list", and press the ENTER button.
The NetLinx Master should return:
"The following URLs exist in the URL connection list"
"->Entry 0-192.168.1.1:1319 IP=192.168.1.1 State=Issue Connect"
The URL list can also be managed in NetLinx Studio™, under "NetLinx Diagnostics".
i!-VotingManager
Appendix
19
Advertisement
Table of Contents
