Calibrating Pots; Connecting Multiple Rts1S - AMX AXC-TEMP AND RTS-1 TEMPERATURE CONTROL CARD AND ROOM TEMPERATURE SENSOR Instruction Manual

Pre-Installation
4. Hold the card by the tab end and slide the card into the frame. Make sure the card is correctly
positioned in the guide slot.
5. Gently push the card in until it is firmly seated in the card connector slot. It is not necessary to
disconnect the power to the CardFrame when installing the card.

Calibrating POTs

Use the four calibration potentiometers (POTs), marked CH 1 - CH 4, to adjust the respective RTS1
units 1 - 4. The default setting for each POT pointer is 0°. The table below describes the POT
calibration for CH 1 - CH 4.
Calibration POTs CH1 - CH4
POTs
R1
R8
R2
R9
R33
R34
R35
R36

Connecting Multiple RTS1s

FIG. 5 shows the pinout for the AXC-TEMP when connecting multiple RTS1s.
PIN 1
PIN 16
FIG. 5 AXC-TEMP pinout for multiple RTS1s
4
Description
Offsets input CHAN1 by -4 to +4 degrees
Offsets input CHAN 2 by -4 to +4 degrees
Offsets input CHAN 3 by -4 to +4 degrees
Offsets input CHAN 4 by -4 to +4 degrees
Stops Adj for input CHAN 1 (for RTS2 only)
Stops Adj for input CHAN 2 (for RTS2 only)
Stops Adj for input CHAN 3 (for RTS2 only)
Stops Adj for input CHAN 4 (for RTS2 only)
GND
TO RTS1 #1
IN1
PWR
GND
TO RTS1 #2
IN2
PWR
GND
TO RTS1 #3
IN3
PWR
GND
TO RTS1 #4
IN4
PWR
AXC-TEMP Temperature Control Card and RTS1 Room Temperature Sensor