Optional Equipment - Komatsu PC18MR-3 Brochure

MR SERIES C
-3 O M P A C T
E M
ASY AINTENANCE
Tilt-up Operator Compartment
Operator's compartment floor tilts forward
providing easy access to hydraulic compart-
ments.
Fully Opening Engine Door
and Side Cover
Allow easy access for daily checks and reg-
ular maintenance.
High Strength X-track Frame
X-track frame is a large hydraulic
Wide opening
excavator concept and deters
dirt and debris build up
saving the operator
valuable time when
cleaning the
machine.
Round shape design
O-ring Face Seal
O-ring face seals are highly
reliable.
8
H E
Y D R A U L I C X C A V A T O R
Photo may include optional equipment
Larger Diameter Swing Pin
Has high durability and
maintains suitable clear-
ances between pin and
bushing after long-term
operation.
DT Connector
DT connectors are moisture
and dust resistant.
COMPACT HYDRAULIC EXCAVATOR
F
EATURES
Two-post ROPS & OPG Canopy
ROPS [Roll-Over Protective Structures]
This canopy meets the requirements of ROPS, with the
advantage of a two-post design.

OPTIONAL EQUIPMENT

Roadliner (not available for PC18MR-3 and PC20MR-3)
Replacement is fast, easy and cost
efficient as individual shoes are
replaced when damaged or worn
instead of replacing the entire track.
Steel Shoes with Optional Blade
Rubber Pad
(Bolt-on cutting edge type)
MR SERIES
-3
Neutral Engine Start System
Locks out drives and hydraulics during machine start up.
Tie-Downs or Anchor Points
Large tie-downs or anchor points in the track frame and
blade allow the machine to be secured quickly for transport.
PA Blade (not available for PC18MR-3,
PC20MR-3 and PC27MR-3)
Blade angle
20 degrees
20 degrees
9