TAPCO TOOLS PRO CUT-OFF Manual

FEATURES
• Quickly, safely and easily makes factory quality
cut offs in coil, PVC coated coil and all vinyl.
• Cuts up to .030 aluminum and all vinyl straight
and accurate with a burr-free edge every time.
• Lightweight aluminum construction built to last.
• Hardened and captured tool steel cutting knives.
• Eliminates use of dangerous utility knives
and shears.
SETTING UP CUT-OFF
LIST OF PARTS: (1) Pro/MAX Cut-Off, (2) Material Stop Kit #11404, (2) Coupling Nut Kit #11420,
(1) Storage/Coupling Nut, (1) Hinge Clip Kit #11413, (1) 10-24 x 5/8" Phillips screw.
Tools Needed for Initial Set Up:
Hemming Handle
Faspin
1
Disconnect the Hemming Handle from
your Bender by releasing the Faspins.
This will allow the Bender to fully open
making it easier to slide Cut-Off Stops
onto the Pivot Arms.
4
Secure the tape measures in place
by "punching" down the edge of the
pivot arm onto the tape measure. Use
a standard nail set or punch.
See other side for operating instructions
Produces factory
quality cuts in coil
stock and vinyl
siding right on
your Port-O-Bender
saving you time,
reducing waste and
conserving the life of
your Port-O-Bender.
hammer, punch or nail set, 9/16" wrench, Phillips screw driver.
Open Bender as
wide as possible.
2
Slide material stop onto Pivot Arms
fromrear as shown.
Note: Recommended locations are
on the second castings in from each
end of your bender.
5
Use a 9/16" wrench to remove exist-
ing Coupling Nut and replace with
new, longer Storage/Coupling Nut.
®
From
The leader in tools for
the professional
Pro Cut-Off shown
• Saves time and labor in scoring and breaking off material.
• Pays for itself by reducing scrap and eliminating
knifing damage to costly bending hinges.
• An indispensable tool for every professional!
Pivot Arm
Casting
IMPORTANT:
5" mark on tape
measure should
be inserted first.
3
Slide measuring tapes into Pivot Arm
slots from rear of Pivot Arm till they
stop. Tape measures take into
1
account 1 / " difference between the
2
bending edge and the shear point of
Cut-Off for accurate cuts.
IMPORTANT!
Read this safety
information before using product.
1. Always keep hands and fingers clear of
the knives during all phases of use.
2. If using both hands to push tool
through material, ensure hands are not
in the path of the exiting material as it
leaves the rear area of the tool.
3. Remove cut-off from anvil prior to
bending material. Failure to do so can
cause the tool to fall from brake
resulting in tool damage or personal
injury to user.
4. Never use tool to cut material not firmly
clamped in brake.
U.S. & Foreign
Pats. Pend.