Remove all parts from box STEP 1: ATTACH WIDTH ADJUSTER Attach the Width Adjuster to the back rail in between the castings, approximately 4' apart (Fig. 1). Tighten the thumb screw. INSTALLATION INSTRUCTIONS Fig. 1 STEP 2: PIVOT BAR ASSEMBLY Note: Pivot Assembly is shipped set up for a Pro 14 install.
Page 2
STEP 3: APPLYING 3” MEASUREMENT STICKER STEP 4: APPLYING GREY/WHITE MEASURING TAPE Remove the Material Stop from the Pivot Bar. Insert 12"x12" piece of coil marked at 6" into the brake and lock it lined up at the 6" mark (Fig. 6). Pull/slide the Material Stop toward Apply the measurement sticker with the -3"...
Page 3
Repeat process for remaining Pivot Bar Assembly. Fig. 10 USING THE S2X MATERIAL STOP GAUGE: Use the Measurement mark on the S2X Gauge to measure any piece wider than 6’’ . Use the Measurement -3" mark on the S2X Gauge to measure any pieces narrower than 6’’...