Mr. Beams MB720 Installation Instructions

Installation Instructions
Wireless Motion Sensor LED Stick Anywhere Light
MB720-723
Thank you
for purchasing the Mr Beams
Stick Anywhere Light. We are committed to
eliminating darkness using the latest in
Light-Emitting Diodes (LEDs). LEDs are the most
efficient and durable light sources available. We
are certain that your light will contribute to a safer
environment and provide light where you need it at
a very reasonable cost.
What is included per light:
• Wireless LED Stick Anywhere Light
• 2 Screws & Double Sided Tape
• Mounting Bracket
What you need to install:
• 1 Small Screwdriver
• 4 AA-Cell Alkaline Batteries (per light)
Stick Anywhere Light Features:
Motion/Light Sensor: Light instantly turns on when it
detects motion from up to 15 feet away. The light sensor
conserves battery life by preventing the light from
activating in daylight.
Auto Shut-off: Stick Anywhere Light shuts off
automatically after 30 seconds if no motion is detected.
Bright LED: 20 Lumens covers up to 10 sq ft.
NOTE: Light sensor only allows light to activate in darkness. We recommend you test in a dark room or closet.
1. Remove mounting bracket from back of light.
Remove battery door by turning 2 thumb screws
counter clockwise.
4. Mount bracket to wall with double sided tape,
holding for 10 seconds or install with 2 small
screws. Note: This is a strong adhesive that
may cause damage to mounting surface. Please
consider your location before mounting.
Battery Caution:
1) Do not mix old and new batteries
2) Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium)
or (Nickel Metal Hydride) batteries
3) Do not dispose of batteries in fire
4)Batteries should be recycled or disposed of as per state and local guidelines
www.mrbeams.com
Tips:
®
•
Use only new alkaline AA-Cell batteries with 1.5V rating.
•
Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.
•
Install batteries with polarity in correct position.
•
Light may activate when batteries are inserted. Simply take light into a dark room. Allow
batteries to settle, then test activation.
If your light will not turn off, it means that it is time to replace the batteries.
•
LED Light
2. Insert 4 Fresh AA alkaline batteries.
5. Slide light onto mounting bracket
attached to wall.
Motion & Light
3. Close battery door and replace
thumb screws.
* Visit our website to view installation video.
* 1 year limited warranty. Visit site for details.
32333 Aurora Rd. Suite 100 Solon, OH 44139
877.298.9082
Sensor