Samsung WEP200 - WEP 200 - Headset Quick Start Manual

Before using your headset
Thank you for purchasing the Samsung Bluetooth
Quick Start Guide
Mono Headset WEP200, we hope you will be
delighted with its operation.
Take a moment before you get started to
Bluetooth Mono Headset
familiarize yourself with your new headset.
WEP200
Get connected in 4 quick steps
Charge your headset
Put your headset in pairing mode
Turn on Bluetooth on your phone and
pair with headset
Volume control
Test and use
Start here
Headquarters:
1301 East Lookout Drive Suite 150
Richardson, TX 75082
Internet Address:
http://www.samsungmobileusa.com/
accessories
Customer Care Center:
1-888-987-4357
Guide No.: GH68-11254A
08/2006. Rev. 1.2
Check the accessories Check the accessories
Make sure you have the following items with your Make sure you have the following items with your
headset: headset:
Set 1:
Charging case, Travel adapter, Manual, Charging case, Travel adapter, Manual,
2 headset hooks 2 headset hooks
Set 2:
Multi-Function button
Charging case, Manual, 2 headset hooks Charging case, Manual, 2 headset hooks
For Set 2, use your phone charger as a For Set 2, use your phone charger as a
power source for recharging. power source for recharging.
Hook
Indicator light
Microphone
buttons NOTE:
Your headset supports the headset and/or hands-free
Charging contact
profile(s).
Put your headset in Turn on Bluetooth on your
pairing mode phone and pair with headset
1
Before you can use your headset, you must pair it
with your phone.
1
Ensure that the headset is off (see Turn
headset on/off on the reverse side of this guide).
2
Press and hold the Multi-Function button until
the indicator light turns on in blue
(approximately 8 seconds).
2
3
The indicator light flashes in blue as you press and
4
hold the Multi-Function button. Continue holding
down the button until the blue light is steadily lit.
Charge your headset Charge your headset
Charge the headset's battery fully before using
the headset for the first time.
1
2
Test and use
Your phone and headset are now paired and
ready to make and receive calls. To confirm
Set your Bluetooth phone to discover the
they are operating properly, make a call:
headset by following your phone's guide.
1
Typically, the steps involve going to the Settings,
Connection, or Bluetooth menu on your
phone and then selecting the option to discover
Bluetooth devices. 2
Your phone will find the Samsung WEP200
headset. 3
Select Samsung WEP200.
After you have successfully paired your phone
When the phone asks if you want to pair with it,
and headset, you do not need to repeat these
confirm by selecting Yes or OK.
initial setup steps each time you use the
Enter the headset passkey or PIN, 0000. headset.
3 Plug the travel adapter into the electrical
outlet.
• For Set 1, use the travel adapter provided.
• Charge the headset until the red light on the
Put the headset in the supplied charging case
headset turns to blue.
and close the cover.
• The headset will be fully charged in
approximately 2 hours.
4
Remove the travel adapter from the case.
NOTE:
The headset cannot be used while charging.
Plug the travel adapter into the case's
charging socket.
Using your WEP200
Place the headset over your ear.
See Wearing the headset on the reverse
side of this guide.
See Features and Functions Guide
On your phone, make a call to the number
on the reverse side of this guide
for information on using your
you want.
WEP200.
If your phone and headset are successfully
paired, you will hear ringing on the headset.